TROUBLE SHOOTING
.stl
A common file format for 3D Designs/Models.
USB Cable
This cable allows communication between the Eazao 3D Printer and a computer, using
the USB port of the computer.
9.1.4 Note Supplement.
1. After a long period of stagnation (more than 6 hours), first remove the tube from the
extruder and select the pre-extrusion mode to extrude the hardened clay from the tube
to ensure the softness and hardness of the clay during printing. Moderate. At the same
time, clean the clay in the extruder, and make sure that there is no too hard clay to block
the extruder or the feeding tube every time it is used.
Note:
If the electric putter produces a clicking sound, it means that the clay in the
feeding tube is too hard. At this time, first soak the whole feeding tube in water to
make the clay in the feeding tube soft. Do not connect the tube to the extruder. , Try to
squeeze out again.
2. If the clay leaks from the top of the extruder tailstock, you need to replace the new
sealing ring.
37
To Next Page
Loading...
