EBO KT-LCD3 - C2 Motor Phase Classification Coding Mode; C2 Display; C3 Pedal Assist Level Initialization; C3 Display

C2 Motor Phase Classification Coding Mode
The C2 Parameter setting will display on the LCD after C1 settings. The KT-LCD3 will display
as follows:
C2 Display
C2 Parameters set the different phases of the motor when using a sine wave drive. The
default value is 0, indicating that the used Quantum motor phase is standard. When the
Parameter is set as a specified value, a particular motor phase is selected. The range of
values for C2 are between 0-7.
C3 Pedal Assist Level Initialization
The C3 Parameter setting will display on the LCD after C2 settings. The KT-LCD3 will display
as follows:
C3 Display
C3 Parameters are settings for the pedal assist level ratio from 0 – 8.
22