EBO KT-LCD3 - C4 Throttle Function Setting; C4 Display; C5 Controller Maximum Current Setting; C5 Display

C4 Throttle Function Setting
The C4 Parameter setting will display on the LCD after C3 settings. The KT-LCD3 will
display as follows:
C4 Display
C4 settings are for the throttle functions. The setting range is 0-5. This is accompanied by a
table below, defining each value.
C4 Value
Throttle in PAS Level = 0
Throttle in PAS Level = 1 - 5
0
No Throttle
Full Throttle Control
1
No Throttle
Throttle Limited to 6Km/h
2
No Throttle
Throttle Speed
Programmed to Rider's Specification
23
Full Throttle Control
Full Throttle Control
4
No Throttle
Throttle is Dependent of PAS Level and
Entered Ratio: 30 - 60
5
No Throttle
Full Throttle Control
C5 Controller Maximum Current Setting
The C5 Parameter setting will display on the LCD after C4 settings. The KT-LCD3 will
display as follows:
C5 Display
23