C9 Startup Password Setting
The C9 Parameter setting will display on the LCD after C8 settings. The KT-LCD3 will
display as follows:
C9 Display
C9 is the settings for password feature upon startup. The default value is 0. Refer to the
following table for definition of the function.
When the feature has been enabled and confirmed by pressing the button, the
display will change to the following.
Password Setting Interface
From here the rider can set the 3-digit passcode starting from the left and sequentially
progress to the right. Password value range is 000-999. Select the values with the
button, button, and confirming the selection with the button.
PLEASE NOTE: If password is forgotten, the Parameters can only be copied (see
Parameter copy) by data source LCD prior to being decoded.
To Next Page
Loading...