EBS EBS-230 - Other Printer Parameters; Auto Start; Operation of Photo-Detector

 EBS-230 Printer User's Manual
 40 ___________________________________________________ 20080512#1.0
Fig. 3.3.9.20.
3.3.10. Other Printer Parameters
Auto Start
The Auto start parameter enables the printer to resume printing automatically after an unexpected
interruption, for example due to a power failure. After the operating conditions have been restored, the
printer switches on automatically and starts printing the texts that it was printing when its operation
was disrupted. The text is printed from the beginning irrespective of where the previous printing was
interrupted. An ink bottle with a transponder connected to the ink system is the prerequisite for
resumed operation. In order to activate the parameter, tick it in the
Parameters 3 tab sheet.
Fig. 3.3.10.1.
Operation of Photo-detector
Printing can be triggered by blocking or unblocking the photo-detector (except when iterative printing
is set to
Continuous). When the photo-detector is shaded, printing is released, as standard. The
Inverse fotocell signal parameter can be used to trigger the photo-detector release mode to
exposed.
The
parameter is available in the Advance tab sheet after the Adv. options box has been ticked.
Fig. 3.3.10.2.