SMS notifications, RS232, Link control, and Phone line. An unauthorized attempt to
access to this parameters causes error notification.
Default installer code: 2222.
8.1.1.2. Group: SIM Cards
SIM Card PIN
As a device operates via GSM network, SIM card is indispensable and it may be
received from phone operator. Before the first use PIN code of SIM card shall be
programmed for operation in given transmitter. PIN code is indispensable for
automatic system launching. In case of card without PIN code, it is possible to enter
any value e.g. 0000.
If you enter wrong PIN number after inserting card and switching on transmitter, the
system will not launch and you may be able to use card after entering PUK card only
(with use of any GSM mobile phone).
Factory setting of PIN in transmitter is 1111.
8.1.1.3. Option: Embedded HTTP server
Selecting this option allows to configure the basic parameters for the EPX400
connection to the server through a Web browser. The method of this configuration is
described in chapter "6. Pre-configuration via Ethernet port"
NOTE: To avoid unauthorized tampering with the device, the manufacturer
recommends that you disable this option when you install the GPRS Transmitter
Configurator (This option is factory-set on).
To Next Page
Loading...
