20
Operation
Starting the cold engine
Starter handle
1. Ignition switch. 2. Throttle trigger lockout. 3. Throttle trigger.
4. Throttle latch. 5. Choke knob.
Before starting engine make sure cutting attachment is not in touch with ground or other
objects.
Place ignition switch in the "start" position.
Pull choke knob to close ( ) position.
Pull starter handle until first firing sound.
Open ( ) choke.
Restart engine and allow to warm up.
When engine is hard to start, use throttle latch.
Pull throttle trigger fully and lower throttle latch while pressing throttle trigger lockout and
release throttle trigger to activate throttle latch.
After engine starts, pull throttle trigger slightly to release throttle latch immediately.
Starting the warm engine
Place ignition switch in the "start" position.
Move choke knob to open ( ) position.
If tank is not empty, pull starter handle.
If fuel tank is empty, refuel first and then pull starter handle.
WARNING
When engine starts, the cutting attachment may rotate, even with throttle trigger in
low-speed position.
After engine starts, pull throttle trigger slightly to release throttle latch
immediately.
Never use throttle latch for operation.
When engine is started, confirm if there is not any abnormal vibration or sound.
If there is abnormal vibration or sound, ask your dealer to repair.
NOTE
Check unit for loose nuts, bolts and screws before starting.
Always clear work area of debris before starting operation.
Always hold the unit firmly on the ground.
When pulling starter handle, use short pulls, 1/2 to 2/3 of rope length.
Do not allow the starter handle to snap back against the housing.
NOTE
If engine does not start after 4 pulls, use cold starting procedure.
To Next Page
Loading...
Need help?
General
