26
Cleaning silencer
1. Silencer cover. 2. Silencer. 3. Two bolts. 4. Hexagonal wrench.
Remove silencer cover.
Clean deposits from silencer and tighten two bolts.
Install silencer cover.
Angle transmission
1. Angle transmission. 2. Plug (bolt). 3. Drain screw.
Remove the plug and drain screw from the angle transmission.
Add grease into the transmission until old grease is pushed out.
If necessary, use a low pressure pump.
Reinstall the drain screw and plug.
NOTE
Use good quality lithium multi grease.
To Next Page
Loading...
