EchoStar DSB-2200 2Ci Viaccess - Delete a Timer

Operation Section 5
EchoNAV User Interface Page 5 - 11
© 2001 EchoStar International Corporation
All rights reserved
5
3.2. DELETE A TIMER
3.3. USE THE INFOBANNER RELATED FUNCTIONS
3.4. TO SELECT THE ALTERNATE AUDIO
13. Save the timer:
a. use the  key, to go to the Store Settings;
b. read the available help text for information;
c. press the OK key to confirm the settings.
14. Note the clock that appeared in your program.
15. Do not forget to program also your VCR.
If the timer screen does not disappear, you have set a
timer in the past or for a running program. Revise
either date, start or stop time to a time in the future
1. On the RCU:
a. press the EPG key;
b. press the GREEN key;
c. select from the list: Timers;
d. press the OK key.
2. Select the applicable timer and press the OK key.
3. Change the status:
a. use the  key, to go to the status;
b. read the available help text for information;
c. press thekeytosetthestatustoinactive.
4. Delete the timer:
a. use the  key, to go to the Store Settings;
b. read the available help text for information;
c. press the OK key to confirm the deletion.
1. On the RCU, press the i-key.
2. If available, allow the receiver to collect the EPG
information for the selected channel.
3. If the i-button in the InfoBanner is shown,
use the i-key on the RCU to shift between the
detailed program information and the InfoBanner.
4. On the RCU, press the EXIT key to remove the
InfoBanner from the screen (only in TV-mode).
1. On the InfoBanner, find the alt audio symbol.
2. On the RCU, press the key.
3. In the Alt. Audio pop-up menu, select the required
alternate audio.
Note that alternate audio information is provided by
the service provider.
4. On the RCU, press the key twice.