EchoStar DSB-2200 2Ci Viaccess - Initial Receiver Installation Guide; Guided Setup Menu Overview

Installation Section 3
EcoNAV User Interface Page 3 - 1
© 2001 EchoStar International Corporation
All rights reserved
3
INSTALLATION
1. THE INITIAL GUIDED SETUP MENU
FOR FIXED AND DISEQC1..4SWITCH INSTALLATIONS
FOR MOVEABLE DISH INSTALLATIONS (DISEQC1.2)
Languages ■ To set the language you want to use in the menus.
■ To set the language for programs with bi-lingual audio.
■ To set the language for bi-lingual subtitled programs.
TV System
■ To set the (UHF) TV channel to which the receiver is
connected.
■ To set the video format supported by your TV.
User Profile
■ To set the screen size of the TV.
■ To set the view time for the InfoBanner.
■ To tell the receiver that it is connected to a Dolby Digital
amplifier or not.
Local Time
■ To set the time zone where you are.
■ To set the actual date.
■ To set the actual time.
System Setup
■ To set the dish type you use.
■ To set the amount of LNBs you have installed.
■ To set the switch type which you use to control the dish
installation (if used).
■ To set the LNB type(s) you use.
Check Signal
■ Wait for the Checking Configuration to complete.
Search Channels
■ Wait for the search to complete.
Languages
■ To set the language you want to use in the menus.
■ To set the language for programs with bi-lingual audio.
■ To set the language for bi-lingual subtitled programs.
TV System
■ To set the (UHF) TV channel to which the receiver is
connected.
■ To set the video format supported by your TV.
User Profile
■ To set the screen size of the TV.
■ To set the view time for the InfoBanner.
■ To tell the receiver that it is connected to a Dolby Digital
amplifier or not.
Local Time
■ To set the time zone where you are.
■ To set the actual date.
■ To set the actual time.
System Setup
■ To set the dish type you use.
■ To set the amount of LNBs you have installed.
■ To set the switch type which you use to control the dish
installation (if used).
■ To set the LNB type(s) you use.
Program Satellites
■ To set the satellite you want to scan for the LNB.
■ To select a transponder of the selected satellite.
■ To move the dish for best signal level and quality.
Search Channels
■ Wait for the search to complete.