EchoStar DSB-2200 2Ci Viaccess - Software Maintenance and Installation; Changing Receiver Setup and Updates

Maintenance Section 6
EchoNAV User Interface Page 6 - 1
© 2001 EchoStar International Corporation
All rights reserved
6
MAINTENANCE
1. SOFTWARE MAINTENANCE - INSTALLATION
1.1. TO CHANGE THE SETUP OF THE RECEIVER
NOTE
FTA (Free-To-Air) receivers have no conditional access capabilities.
If shown, please ignore the Conditional Access button in the main menu bar.
NOTE
Unless otherwise specified; This note explains the way you can navigate through
the maintenance pages of the EchoNAV setup menu.
1. Use the OK key to pull down the menu selection fields.
2. Use thearrow keys to go through the selectable menu items.
3. In a pull-down menu, use the OK key to confirm the selection.
4. Use thearrow keys to navigate between the left and right column of
selectable menu items.
5. Use the EXIT key to leave the menu and return to the live mode.
1. On the RCU, press:
a. the MENU key;
b. the  key to select the menu;
c. the OK key, to select the or menu.
2. Press the OK key and make the selections.
3. Read the available help text for information.
4. Go to the Check Signal field.
5. On the RCU, press the OK key.
6. Wait for the Check Signal page to appear.
7. In the Check Signal menu make the required
selections for transponder and search mode.
8. Read the available help text for information.
9. If the red dot in the transponder field stays:
a. select another transponder;
b. go to the check signal field;
c. on the RCU, press the OK key.
10. Go to the Search Channels field.
11. On the RCU, press the OK key.
12. Wait for the search to complete:
a. the receiver display shows a moving dot;
b. the search completed popup menu appears.
13. On the RCU:
a. press the OK key to save the settings;
b. press the EXIT key to leave the menu.
.