Maintenance
Section 6
EchoNAV User Interface Page 6 - 3
© 2001 EchoStar International Corporation
All rights reserved
6
1.5. TO DO A FACTORY RESET
2. SOFTWARE MAINTENANCE - CONDITIONAL ACCESS
2.1. TO GET CONDITIONAL ACCESS INFORMATION
FOR 2CI
FOR EMBEDDED VIACCESS
NOTE
Be sure if you select Memory Erase because all your personal settings will be
deleted and replaced with the factory settings. Some of the personal settings that
will be deleted are Parental Lock, Favorite lists and System setup. Memory erase
resets the receiver as if the receiver comes just out of the box.
1. On the RCU, press:
a. the MENU key;
b. the key to select the menu;
c. the OK key, to select the menu.
2. Press the OK key and make the selections.
3. Read the available help text for information.
4. Go to the Confirm Reset field.
5. On the RCU, press the OK key.
6. Wait for the Languages initial setup menu to appear.
7. Do the initial setup, refer to the section Installation
for detailed instructions.
NOTE
FTA (Free-To-Air) receivers have no conditional access capabilities.
If shown, please ignore the Conditional Access button in the main menu bar.
1. On the RCU, press:
a. the MENU key;
b. the key to select the menu;
c. the OK key, to select the menu.
2. Press the OK key and make the selections.
3. Read the available help text for information
1. On the RCU, press:
a. the MENU key;
b. the key to select the menu;
c. the OK key, to select the menu.
2. Press the OK key and make the selections.
3. Read the available help text for information.
To Next Page
Loading...
