EC-PM-80320 User's Manual
- 7 -
2.5 Installing the Driver
Please use the cable to connect computer with printer, then turn on the computer and the printer, put
the driver CD into the CD-ROM. Install driver by the following ways:
2.5.1 Auto-installing Way (Recommended)
Double click the file "Setup.exe" in the driver disc, install driver by the guide.
2.5.2 Hand-operated Installing Way
2.5.2.1 The Operating Systems of Windows 2000/XP/Vista/Win7
(1) The hand-operated installing steps of parallel interface or serial interface:
The following steps are used Windows XP as an example. There are slight differences among
different operating systems. The installing way with other operating systems depends on the
practical installing process.
1 Click “Start” → “Settings” → “Select Printers”.
2. Click “Add Printer”, then it pops up a window of “Add Printer Wizard”, click “Next”, then please
read the select guide carefully, such as, select “Local printer” in the “Local or Network Printer”
window, then click “Next”.
3. A window of “Select a Printer Port” pops up, according to your requirement, select “LPT1:
(Recommended Printer Port)” or serial interface, click “Next”.
4. A window of “Install Printer Software" pops up, click “Have Disk...”.
5. A window of “Install From Disk” pops up. Please according to the operating system environment,
you should select the path as follows: CD-ROM → “Drivers” → “WIN2000 (XP-Vista-Win7)”, click
“Open”, then click “OK” to return to the window of “Install Printer Software”, click “Next”.
6. Follow the guide and click “Next” gradually till the installation is finished.
(2) The hand-operated installing steps of USB interface:
The following steps are used Windows XP as an example. There are slight differences among
different operating systems. The installing way with other operating systems depends on the
practical installing process.
1. Connect with the USB cable and turn on both the computer and the printer. After the computer
finds out new hardware, and a window of “Found New Hardware” pops up — “Welcome to the
new hardware wizard”.
2. Select the “Set from the list or specific position”, then click “Next”
3. A window of “Please choose your search and installation options” pops up, choose “Don't search,
I will choose the driver to install”, click “Next”.
4. A window of “Add Printer Wizard” pops up, click “Have Disk...”.
5. A window of “Install From Disk” pops up. Please according to the operating system environment,
you should select the path as follows: CD-ROM → “Drivers” → “WIN2000 (XP-Vista-Win7)”, click
“Open”, then click “OK” to return to the window of “Add Printer Wizard", click “Next”.
6. Follow the guide and click “Next” gradually till the installation is finished.
Note: Auto-installing way needs the operating systems of Windows2000 and above and
the operating systems of Window 98/ME and below are not supported.
Note: This installing way is used for the people who have some knowledge on
hand-operated installing and equipment application.
To Next Page
