For
your
safety
in
using
the
CD1200
For your safety
in
using the CD1200
Warnings and caution signs, illustrated below, are posted throughout this manual as well
as
on
the
CD1200. They show safe
and
correct ways to handle the product
so
as
to
prevent personal injury to
you, others and to avoid property damage.
Before reading through the manual, take time to read through and learn the important information listed
in
this section.
This "Warning" sign indicates a situation
in
which incorrect
& Warning handling
or
disregard
of
this sign might result in death or
serious personal injury.
This "Caution" sign indicates a situation
in
which incorrect
& Caution handling or disregard
of
this sign might result
in
personal
injury or may result solely in damage to property.
Please read
all
materials such
as
manuals and warranties that have come with the product.
Eclipse will not
be
held liable for unsatisfactory product performance due to failure to follow these
instructions.
~WARNING
• Do
not
modify
this
system
for
use
other
than
that
specified herein.
Also,
do
not
deviate
from
the installation
procedures
described
herein; ECLIPSE
will
not
be held liable
for
damages
including,
but
not
limited
to
serious
injury, death
or
property
damage
resulting
from
installations
that
enable
unintended
operation.
• This
main
unit
reqUires 12V
DC
and
should
only
be installed in a vehicle
with
a 12V negative
ground
electrical system.
Any
other
installation
may
cause a fire
or
other
severe damage
to
the main
unit
and the vehicle.
• Never install
this
main
unit
where
it
will
interfere
with
safe operation
of
the
vehicle. Never
block
the
drivers'
view. Do
not
install main
unit
where
it
may
interfere
with
operation
of
the
brakes,
the
steering
or
any
safety
equipment,
including
seat belts and
air
bags.
• Before
drilling
holes
in a vehicle
for
installation,
you
must
confirm
the
locations
of
pipes,
tanks, electrical
wiring,
and
other
vehicle
systems
and
components
to
ensure
that
there
will
be
no
interference
or
contact. In addition,
you
must
also
apply
rust
prevention and leak
prevention measures at the
drilling
area. Otherwise, fire
or
electric
shock
could
occur.
• When
installing
main
unit
do
not
remove
or
alter
eXisting vehicle fasteners,
including
nuts,
bolts, screws, clips, and
fittings.
Never detach,
move
or
alter
eXisting
vehicle
wiring,
including
electrical
grounds
and straps.
Alteration
of
existing
vehicle
components
may
make vehicle unsafe
to
operate.
• Before installation, remove
the
negative (-) battery terminal
to
prevent
shocks,
electrical
arcing, fires, and damage
to
vehicle
wiring
and
the
main
unit
you
are installing.
• Secure
wiring
with
tape
or
plastic
ties
so
that
wires
do
not
interfere
with
vehicle operation,
including
brake pedal, gear
shifter
and steering.
Position
wires
so
that
they
will
not
be
rubbed, abraded,
or
damaged
by
moving
vehicle
components,
including
power
seats.
•
To
avoid
main
unit
and vehicle damage,
including
fire,
never
supply
power
to
the installed
main
unit
in a
way
which
will
overload the capacity
of
an
existing
vehicle
circuit.
Never
leave a
power
supply
wire
or
connection
uninsulated.
Always
install
supplied
fuses,
circuit
breakers, and relays.
2
To Next Page
Loading...
