, Operation
How to operate the CD/MP3IWMAJAAC player
About compact discs
• The signal recorded on a compact disc
is
read by a laser beam, so nothing touches the disc surface.
A scratch on the recorded surface or a badly warped disc may cause deteriorated sound quality or
intermittent playback. Observe the following precautions to ensure high quality sound performance:
c
~o
About brand new CDs
Rough
Edges
Flakes
r-~~
~~
1
Recorded surface
16
• Do not leave
an
ejected disc
in
the disc slot for very long; the disc may
warp. Discs should be stored in their cases and kept away from high
temperature and humidity.
• Do not adhere of paper or tape. Do not write on or scratch either side
of a disc.
• Discs spin at a high speed inside the main unit. Keep cracked
or
warped discs out
of
the player to avoid damaging the main unit.
• Avoid touching the recorded surface when handling a disc; handle
discs by their edges.
•
You
may notice that some brand new discs are rough around the
center hole or outside edge. Remove the rough edges with the side
of
a ballpoint pen, etc. Rough edges may prevent proper loading
in
the
main unit. Flakes from the rough edges may also stick to the recorded
surface and interfere with playback.
To Next Page
Loading...
