Ecobee EMS Si - Configuring a Web Portal Account

Do Nothing No specic action will occur.
Switch to Occupied* Switches the system
to the Occupied program when the input
is activated.
Switch to Unoccupied* Switches the
system to the Unoccupied program when
the input is activated.
* The Economizer and/or Occupancy relay
outputs, if congured, will also be switched
to the appropriate state when this input is
congured and activated.
Shutdown Compressor The compressor
(both for AC or Heat pump) will shutdown
and remain shutdown until this input is
cleared
Shut down AC The air conditioning system
will shutdown and will remain shutdown
until this input has cleared
Adjust Temperature The heat and/
or cool set points will be adjusted by a
preprogrammed amount. It will revert back
to the original set point when the input has
cleared.
Turn On Fan The fan will be set to On. It
will revert back to its original settings when
the input is cleared.
Disable Auxiliary Heat The auxiliary heat
equipment will be disabled. It will be re-
enabled when the input is cleared.
Shutdown All HVAC All equipment will be
disabled. It will be re-enabled when the
input is cleared.
Disable All Heat All heat equipment will
be disabled. It wil be re-enabled when the
35