ECOFOREST ecogeo basic - Terminal and Buffer Status; Compressor and Expansion Valve Data; Energy and Demand Monitoring

Technical service manual ecoGEO
19
EN
2. Controller Technical Service Guide
To access the installer menu, press at the same time. Afterwards, enter access password PW1. This menu is used to define
the type of installation and the services the heat pump will deal with, to adjust the various operation parameters and protections as
well as to carry out various start-up and maintenance operations.
This menu shows the sub-menu structure of the INSTALLER menu.
INSTALLER menu
Sub-menu level 1
Sub-menu level 2
Sub-menu level 3
1. Language
2. Configuration
2.1. Heat pump model
2.2 Brine
2.3. Services
2.3.1. Heating
2.3.2. Cooling
2.3.3. DHW
2.3.4. Pool
2.3.5. Priorities
2.3.6. Special programs
2.4. Auxiliary equipment
2.4.1. Bivalent parameters
2.4.2. Internal resistor
2.4.3. DHW resistor
2.4.4. Buffer resistor
2.4.5. Boiler
2.5 Remote control
2.6. Protections
2.7. Probe Conf.
3. Manual activation
4. Alarm log
5. Default values
4. Change password
Table 2.1. INSTALLER menu structure.
2.1. Language selection
Language
1. Used to select the language of the heat pump controller.
Language
1. Used to enable the language selection screen that appears on launching the controller.
2. Used to adjust the display time of the language selection screen on launching the
controller.
4:5
Installer menu
/
ahange language
bonfiguration
cManual test
/ Language
Language: ENGLISH
ENTE to change
Language
ENGLISH
Disable language mask
at start-up: No
Show mask time: s