ECOFOREST ecogeo basic - ecoGEO HP1;HP3 12-40 kW Specifications

Technical service manualecoGEO
26
EN
2.6. Configuration of the DHW production service
DHW
1. Used to enable the DHW production service.
2. Used to enable use of the circulator pump for the DHW service.
3. Use to enable the use of a DHW recirculation pump.
Legionella protection
1. Used to adjust the setpoint temperature in the DHW storage tank for the legionella
protection program.
2.7. Configuration of the pool service
Pool
1. Used to enable the pool service.
2. Used to adjust the temperature difference between the setpoint temperature of the
pool and the outlet of the heating pump. This parameter must be adjusted to obtain
an appropriate temperature difference in the pool exchanger.
Note: This option is only available for ecoGEO HP models.
3. Used to adjust the target outlet temperature in pool mode. Also used to set the request
logic of the pool.
Note: This option is only available for ecoGEO HP models.
4. Used to enable use of the production circulator pump for the pool service.
Connection type
1. Used to select whether the pool is connected in parallel to the heating circuit or the
DHW circuit (HTR system).
Note: This option is only available for ecoGEO B/C models.
Special parameters
1. Used to adjust the target temperature difference between the production circuit
outlet and inlet in pool mode.
Installer menu
/
ahange language
bonfiguration
cManual test
onfiguration 3/7
bSources
cServices setup
dAuxiliary systems
Services setup
3/
booling
cDHW
dPool
3/ DHW
Enable:
Production pump:
ecirculing pump:
Legionella
SetpointT: 5
Installer menu
/
ahange language
bonfiguration
cManual test
onfiguration 3/7
bSources
cServices setup
dAuxiliary systems
Services setup
4/5
cDHW
dPool
ePriorities
4/5
Pool
Enable:
DTexchanger: 
Production pump:
Pool
Enable:
DI4 logic: NA
Tsupply: 
onnection type
NA

Special parameters
DTpool: 5
