56
Under ACPI (Advanced Configuration and Power manage-
ment Interface) you can create a software power down. In a
software power down, the system can be resumed by Wake
Up Alarms. This item lets you install a software power down
that is controlled by the normal power button on your system.
If the item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. then
you have to hold the power button down for four seconds to
cause a software power down.
Power State Resume Control (Always Off)
This sets the power state after a shutdown due to an unex-
pected interrupt of AC power.
To Next Page
Loading...
