H100N Pulse Oximeter User Manual Safety Information
- 15 -
3 Normal operation means:
— The oximeter is turned on;
— A sensor is connected to the oximeter;
— The sensor is applied to the patient;
— The patient’s SpO2, Pulse rate or
Temperature readings are being reported;
— No error conditions exist.
4 Wash the probe with clean water after
disinfecting it to remove any remaining solution.
The probe can only be reused after being dried
thoroughly.
5 Do not disinfect the probe with the means of
water boiled.
6 Any residue should be removed from the probe
before being disinfected, and avoid contacting
corrosive solvent. Dip the cable into alcohol or
alkalescent solvent for a long time, may reduce the
flexibility of the scarfskin of the cable. Also, the
To Next Page
Loading...
