H100N Pulse Oximeter User Manual Introduction
- 30 -
2.3 Connecting Sensor or Cable
Figure 2-6 Sensor and Cable Connecting Port
SpO
2
Sensor and cable port is on the top of the oximeter
for connecting the SpO
2
sensor. An extension cable can
be used between the oximeter and the SpO
2
sensor. Use
only the cable permitted by the manufacturer.
The cable for connecting the oximeter and PC with the
PatientCare Viewer Data Management Software is also
connected to this port.
The temperature sensor port is only configured for
H100N.
To Next Page
Loading...
