H100N Pulse Oximeter User Manual Oximeter Operation
- 43 -
Error 03 Indicates error for Temp board
Error 04 Indicates error for main control
board
3.2 Measurement State
3.2.1 Measurement Modes
There are two measurement modes which are waveform
mode and large numeric mode. By default, the
configuration is waveform mode.
Large Numeric Mode
The oximeter can display SpO
2
, oxygen saturation unit
(%), PR, pulse rate unit (bpm), TEMP and temperature
unit (℃) in large numeric mode.
Figure 3-2 Large Numeric Mode
To Next Page
Loading...
