EDAN H100N - Powered by Battery

H100N Pulse Oximeter User Manual Introduction
- 32 -
5
Detector Anode Detector anode
connection
6
Inner Shield Detector shield to
GND
7
Outer Shield Outer cable shield to
GND
8
RXD / Sensor
Memory Data
UART Rx /DigiCAL
communication signal
9
Detector Cathode Detector cathode
connection
2.4 Powered by Battery
The oximeter can be powered by four 1.5V LR6 AA
alkaline batteries. It will operate for 48 hours when used
for general operation, or about 24 hours of operation
with the backlight and alarm on. The oximeter does not
support built-in recharging mode.
The oximeter can also be powered by 4 1.2V Ni-MH
rechargeable batteries.