SE-1 Electrocardiograph User Manual Introduction
- 16 -
WARNING
the valid version of the system standard IEC/EN 60601-1-1. If in doubt, consult our
technical service department or your local distributor.
2. The summation of leakage current should never exceed leakage current limits while
several other units are used at the same time.
2.4 Mains Connection and Switch
As the above figure shows, on the left side of the main unit are the mains socket, mains switch
and potential equalization conductor.
1) Potential Equalization Conductor
The potential equalization conductor provides a connection between the unit and the
potential equalization bus bar of the electrical installation.
2) Mains Socket
AC SOURCE: alternating current supply socket
3) Mains Switch
: On
: Off
Mains Switch
Potential
Equalization Conductor
Mains Socket
To Next Page
Loading...
