SE-1 Electrocardiograph User Manual Printing ECG Reports
- 32 -
Chapter 7 Printing ECG Reports
There are four auto modes: AUTO 1, AUTO 2, AUTO 3 and AUTO 4. Two channels,
including a rhythm lead, can be printed together in the AUTO 4 mode. The lead switch orders
in different modes are listed in Table 2-1.
In the auto mode, leads will be switched in order automatically during the printing course.
After the ECG wave of one lead is printed for the set time period, the device will switch to
print the ECG wave of next lead automatically. There is a blank area on the recorder paper
before printing the ECG wave of next lead in the AUTO1, AUTO2 and AUTO3 modes.
Moreover, a 1mV calibration mark will be printed before the ECG wave of each lead. There is
no blank area on the recorder paper before printing the ECG wave of next lead in the AUTO4
mode.
In the manual mode, you can determine the lead to be printed and print the ECG wave of the
selected lead continually.
7.1 Auto Mode
Operation Procedures:
1) Press the MODE key to select an auto mode, which will be displayed in the top left
corner of the LCD screen;
2) If AUTO4 is selected, you can select a rhythm lead on the system setup interface.
3) Press the SENS key to select an appropriate sensitivity. For details about the
signal ranges of different sensitivities, please refer to Section 2.2, “Key Panel and
Keys”.
4) Press the MENU key to open the system setup interface to set the detailed parameters.
Press the MENU key again to return to the main interface. For details about settings,
please refer to Chapter 8 “Settings”.
5) Press the PRINT/STOP key to begin printing an ECG report. The symbol means
that ECG is being printed now. The device will stop automatically after printing a
complete 12-lead ECG report.
To Next Page
Loading...
