SE-1 Electrocardiograph User Manual Settings
- 38 -
8.5 External Input/Output Settings
The external input/output signal interface is equipped in the electrocardiograph, through which
SE-1 can receive ECG signals from external equipment, and transmit ECG signals to external
equipment. There are two options: ON and OFF.
8.6 Key Beep and QRS Beep Settings
KEY BEEP : ON
QRS BEEP : OFF
When KEY BEEP is set to ON, there is a short beep when the keys on the key panel are
pressed.
When QRS BEEP is set to ON, there is a short beep when an R wave is detected.
8.7 Rhythm Lead Settings
RHYTHM LEAD : П
In the AUTO4 mode, ECG waves of a lead and a rhythm lead can be printed. The rhythm lead
can be any one of 12 standard leads: І, П, Ш, aVR, aVL, aVF, V1, V2, V3, V4, V5, and V6.
To Next Page
Loading...
