SE-1 Electrocardiograph User Manual Printing ECG Reports
- 33 -
Pressing PRINT/STOP during the printing course can stop printing the ECG report. When you
begin printing an ECG report later, the system will print the ECG report from the first lead, and
the ID number will increase by one automatically. If the ID number needs to be unchanged,
you should press the ID key to adjust it before printing the report. For details on setting the ID
number, see Chapter 6, “Entering Patient Information”.
Note:
1. The working mode can not be changed during the printing course. Stop printing the
report before changing the working mode.
2. The SENS key is ineffective during the printing course in the auto mode.
7.2 Manual Mode
Operation Procedures:
1) Press the MODE key to select the MANU mode, which will be displayed in the top left
corner of the LCD screen.
2) Press the Lead switch key to select the lead to be printed.
3) Press the SENS key to select an appropriate sensitivity. For details about the
signal ranges of different sensitivities, please refer to Section 2.2, “Key Panel and
Keys”.
4) Press the MENU key to open the system setup interface to set the detailed parameters.
Press the MENU key again to return to the main interface. For details about settings,
please refer to Chapter 8 “Settings”.
5) Press the PRINT/STOP key to begin printing an ECG report.
6) Press the 1mV key to print out a 1mV mark in the ECG report. Press the Lead switch
key to switch the lead while printing the ECG report.
7) Press the PRINT/STOP key to stop printing the ECG report.
To Next Page
Loading...
