TABLE OF CONTENTS INTRODUCTION INSTALLATION OPERATING INSTRUCTIONS APPENDIX
23
Installation Instructions
Ford Juice
FINAL INSPECTION
1. Recheck all connections for a properly secure installation.
2. Using the supplied wire ties, secure the wiring harness and cable
to prevent possible heat damage from hot engine surfaces. (For the
7.3L, pay special attention to the routing of the CMP harness as it
is very close to moving parts.)
3. Reconnect the battery cables.
4. Start the engine. The engine should start and idle like a stock
truck. If the engine does not start or run properly, turn off the
engine. Remove the keys from the ignition, and check the Juice
module connections. Make sure all connectors are fastened tightly.
If you continue to have problems, contact your dealer or Edge
Products, LLC.
(888) 360-EDGE (3343) 8:00 am - 5:00 pm MST
To Next Page
Loading...
