TABLE OF CONTENTS INTRODUCTION INSTALLATION OPERATING INSTRUCTIONS APPENDIX
19
Installation Instructions
Ford Juice
1. Slide the shrink tube pieces over the two wires. Later you will
slide them over the bolted connections. (Figure 5)
2. Connect the (2) ring terminals
to the mating Juice harness terminals
using the supplied hardware.
Yellow to Yellow. Red to Red.
(Figure 6)
3. Tighten the nuts so that each wire is in line with its mating wire.
4. Position the supplied shrink tube over the secure fasteners.
5. Center the connection within the shrink tube. Heat and shrink
Figure 5 - Shrink Tube
Ring Terminals
Shrink Tube
Nut
Bolt
Figure 6 - Hardware Install
CONNECTING THE PROBE TO JUICE
2003-2007
NOTE: Find these exhaust manifold locations by laying on
your back behind the driver side front tire and looking up. The
1999-2003 view shows only the fi tting having been installed. The
2003-2007 view shows the Probe mounted to the fi tting.
EGT Location per year range
To Next Page
Loading...
