128
When Auto Pilot is disabled, select a channel (1-11) manually.
Set the channel bandwidth or use Auto (automatically select
based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
These settings are for experienced users only. Please do not change any of the
values on this page unless you are already familiar with these functions.
Changing these settings can adversely affect the performance of
your AP.
Select “Short” or “Long” – this value is used for contention
windows in WMM.
Set the wireless radio preamble type. The preamble type in
802.11 based wireless communication defines the length of
the CRC (Cyclic Redundancy Check) block for communication
between the AP and roaming wireless adapters. The default
value is “Short Preamble”.
Set the guard interval. A shorter interval can improve
performance.
Enable/disable 802.11n protection, which increases reliability
but reduces bandwidth (clients will send Request to Send
(RTS) to AP, and AP will broadcast Clear to Send (CTS), before
a packet is sent from client.)
The measurement procedure follows clause 5.3.11.2.2 of the
ETSI EN 300 328 V1.8.1
Set the DTIM (delivery traffic indication message) period value
of the wireless radio.
(The default value is 1)
Set the RTS threshold of the wireless radio.
(The default value is 2347)
Set the fragment threshold of the wireless radio.
(The default value is 2346)