Why Edimax Security Camera has no image?
If your Edimax Security Camera displays no image, first, ensure the installation location isn't too dark; adding light might help. Second, check the camera lens for any obstructions.
What to do if can’t connect to Edimax Security Camera?
If you're unable to connect to your Edimax Security Camera, please check the following: Verify the IP address of the network camera. Ensure the network cable is correctly connected to your local area network. Confirm the power cable is correctly connected to the network camera. Check that the network camera is switched on (the LED lights on the network camera will light up), if LED lights are not switched off in the configuration menu (System -> Basic -> LED light).
How to fix Edimax IP Camera when can't connect?
If you're unable to connect to your Edimax IP Camera, here are a few things to check: * Ensure the IP address of the IP Camera is correct. * Verify the network cable is properly connected to your local area network. * Confirm the power cable is correctly connected to the IP Camera. * Make sure the IP Camera is switched on and that the LED lights are illuminated, unless they have been disabled in the configuration menu (System -> Basic -> LED light).
What to do if Edimax IP Camera has no image?
If your Edimax IP Camera is showing no image, consider these solutions: * If the installation location is too dark, adding some lights might help. * Check the lens to ensure nothing is covering it.
Provides essential safety guidelines for using the network camera to prevent harm.
Step-by-step guide for physically setting up the network camera and connecting cables.
Instructions for establishing a wireless connection using the WPS feature.
Steps to access the camera via web browser and install necessary plugins.
How to view the live video stream from the network camera through its interface.
Configuration for wired Ethernet network parameters like IP, Netmask, Gateway.
Steps to configure wireless network connections, including SSID, security, and mode.
Enable/disable motion detection and configure detection intervals and notifications.
Set camera name, administrator password, and control LED behavior.
Step-by-step guide for installing the Windows-based surveillance software.
Overview of the software interface and its components for managing cameras.
Detailed configuration of cameras, recording, audio, and motion detection within the software.
Common problems and their solutions for network camera operation.
General| Resolution | 1280 x 720 |
|---|---|
| Wireless Standard | 802.11b/g/n |
| Video Compression | H.264, MJPEG |
| Audio | Built-in Microphone |
| Type | Indoor |
| Connectivity Technology | Wireless |
| Frame Rate | 30 fps |
| Minimum Illumination | 0.5 Lux |
| Day/Night | Yes |
| Ethernet | 10/100 Mbps |
| Power over Ethernet | No |
| Weight | 200 g |
| Power Supply | DC 5V 1A |
| Features | Motion detection, Night vision |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -20°C to 60°C |
| Humidity | 20% to 80% RH |
To Next Page
