To Next PageTo Next Page
Need help?Do you have a question about the Edwards iGx and is the answer not in the manual?
General| Brand | Edwards |
|---|---|
| Model | iGx |
| Category | Laboratory Equipment |
| Language | English |
Defines the manual's scope and key terms for iGX dry pumping systems.
Details suitable applications for the iGX system, including a chart for process compatibility.
Explains the iGXL system's design, limitations, and suitability for various process gases.
Describes control hierarchy among PDT, MicroTIM, and front panel for the iGX system.
Explains the Active Utility Control (AUC) function for power reduction and energy saving.
Provides specifications like dimensions, mass, noise, and vibration for iGX pumps.
Lists supply voltage, frequency, and motor ratings for iGX systems across different models.
Details centre of gravity and levelling foot loads for iGX pump models.
Outlines connector types and mating specifications for iGX system interfaces.
Covers electrical, water cooling, connections, materials, and operating conditions for iGX pumps.
Guides on positioning, securing, and preparing the iGX system for installation.
Instructions for connecting the pump to vacuum and exhaust systems, including safety precautions.
Guidelines for connecting the nitrogen gas supply, including cautions.
Safety precautions for handling flammable or pyrophoric gases with the iGX system.
Instructions and warnings for using inert gas purges to dilute dangerous gases.
Procedure for leak testing the installed iGX system to prevent leaks.
Step-by-step guide for safely connecting the iGX system to the electrical supply.
Instructions for integrating the iGX system into an emergency stop circuit.
Procedure for connecting cooling water hoses and supply.
Steps for initial system setup and verification before full operation.
Guidance on installing extra safety equipment for process monitoring.
Detailed steps for safely starting the iGX system, including pre-checks.
Explains the meaning of various LED indicators on the iGX system.
Procedures for safely shutting down the iGX system via different control methods.
Describes conditions that trigger automatic shutdown and 'run til crash' mode.
Addresses causes and actions for unplanned shutdowns and alarms.
Instructions on using the emergency stop function to halt the system.
Guide on restarting the iGX system after a shutdown event.
Information on using the SEM for configuration and monitoring.
Outlines safety precautions and recommended frequency for iGX system maintenance.
Procedures and safety advice for moving the iGX system for servicing.
Step-by-step guide to safely drain the cooling water system.
Instructions and cautions for cleaning the iGX pump.
Guidelines for safely transporting the iGX system, including labeling.
Instructions for storing the iGX system in suitable conditions.
Procedures for safe and compliant disposal of the iGX system and its components.
Information regarding returning equipment for service and ordering parts.
Overview of Edwards' global service capabilities and support network.
Lists available accessories for the iGX system with their item numbers.
