A546–00–880 Issue E
Page ii © Edwards Limited 2014. All rights reserved.
Edwards and the Edwards logo are trade marks of Edwards Limited.
Contents
6.3 Disposal ...................................................................................................................31
7 Service, Spares and Accessories .............................................................. 33
7.1 Introduction .............................................................................................................33
7.2 Service ....................................................................................................................33
7.3 Ordering accessories ...................................................................................................34
For return of equipment, complete the HS Forms at the end of this manual.
Illustrations
Figure Page
1 iGX Applications chart .................................................................................................. 2
2 The controls/connectors ................................................................................................ 3
3 The rear status panel LED indicators ................................................................................. 4
4 The front panel controls ................................................................................................ 4
5 Priority of control ........................................................................................................ 5
6 Centre of gravity and levelling foot loads ........................................................................... 8
7 System arrangment to reduce effective footprint (if required) .................................................12
8 High and low volt coding pin arrangement .........................................................................17
9 Method for connecting phase wires ..................................................................................18
10 Connections to emergency stop circuit (systemable) .............................................................18
11 Installing 3/8" quick connect fittings (provided) ...................................................................20
12 Gas module access panel ..............................................................................................21
13 Flow tube (14 slm) ......................................................................................................21
14 Flow tube (4 slm) .......................................................................................................22