© Edwards Limited 2011. All rights reserved. Page 11
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
D395-93-880 Issue A
3 Installation
3.1 Safety
When you refer to a manual supplied as a Supplementary Publication, you must obey all of the WARNING and
CAUTION instructions in the manual.
A suitably trained and supervised technician must install the T-Station.
Check that all the required parts are available and of the correct type before you start work.
Ensure that the installation technician is familiar with the safety procedures which relate to the products
pumped. Wear the appropriate safety-clothing when you come into contact with contaminated components.
Isolate the other components in your system from the electrical supply so that they cannot be operated
accidentally.
Do not reuse O-rings and Co-Seals if they are damaged.
Dispose of components, grease and oil safely (refer to Section 6).
Take care to protect sealing-faces from damage.
We recommend you leak-test the system after installation is complete.
3.2 Unpack and inspect
Remove the outer cover and all packing materials, remove the protective covers from the inlet and outlet ports,
inspect the system for any damage. If the T-Station is damaged, notify your supplier and the carrier in writing within
three days; state your order number and invoice number. Retain all packing materials for inspection. Do not use the
T-Station if it is damaged. Check that your package contains the items listed in Table 6. If any item is missing, notify
your supplier within three days.
If the T-Station is not to be used immediately, replace the protective covers. Store the T-Station in suitable
conditions as described in Section 6.1.
Obey the safety instructions given below and take note of appropriate precautions. If you do not,
you can cause injury to people and damage to equipment.
Table 6 - Checklist of components
Qty Description Check ()
1 T-Station
1 T-Station CD instruction manual P450-00-000
1 Ultragrade 15 oil 1 ltr (supplied only with E2M1.5)
1 Inlet seal (either trapped O-ring, Co-seal or copper compression gasket suitable for
the inlet-flange type)
1 Connector (24 V) - for driving accessories from Podule socket
1 Inlet-strainer
To Next Page
Loading...
