© Edwards Limited 2011. All rights reserved. Page 15
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
D395-93-880 Issue A
Figure 6 - Turbomolecular pump start delay with XDD1 diaphragm pump
3.9.2 Connecting a vacuum gauge
Do not connect Barocel capacitance manometers to the T-Station gauge connector. Doing so will result in
damage to the gauge and will invalidate the warranty.
A single compatible active gauge can be fitted to the T-Station. Fit the gauge using an Edwards active gauge cable
into the gauge connector located on the side of the controller housing (refer to Figure 1). For active gauge control
and set-up refer to Section 4.3.2.
The following Edwards active gauges are suitable for use with the T-Station:
APG100 Active Pirani vacuum gauge
APGX-H Active Linear Convection gauge
AIM-X Active Inverted Magnetron gauge
WRG-S Active Wide Range gauge
ASG Active Strain gauge
To Next Page
Loading...
