D395-93-880 Issue A
Page 24 © Edwards Limited 2011. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
4.3.5.1 Calibrate screen key actions
4.3.6 Units screen
When the Units screen is selected, the menu LEDs are unlit and the currently selected Units LED is lit. The numeric
display is blank.
To change the units press the ENTER key and use the NEXT key to choose between mbar, Torr, Pa and voltage. Press
the ENTER key again to confirm the selection. Note that when voltage is selected the display shows " 0.000".
When the units are changed, the set-point values will be converted to the new units. For example, if a set-point
threshold is entered as 1.0 x10
-3
mbar and the units are changed to Torr, then the value will be displayed as
7.5 x 10
-4
Torr.
4.3.6.1 Units screen key actions
Keys Short Press Long Press
START Go to Turbo Screen -
ENTER Calibrate gauge -
NEXT Go to Units screen Scroll through menu screens
Keys Short Press Long Press
START Go to Turbo Screen -
ENTER Enter edit mode, or confirm selection -
NEXT Next Units option, or
go to Turbo screen
Scroll through Units in edit mode,
or Scroll through menu screens
Calibrate
Chan
e
To Next Page
Loading...
