D395-93-880 Issue A
Page 22 © Edwards Limited 2011. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
Note: If you set the Turbo Set-Point to pressure but do not connect a gauge then the turbo pump will not start.
4.3.4.1 Number entry mode
When the ENTER key is pressed and held on either the time or pressure option number entry mode is entered. The
first digit starts flashing, and the time or pressure can be edited.
Press the NEXT key to adjusts the value, then press the ENTER key to confirm the digit and then move on to the second
digit, which is adjusted similarly. The ENTER key confirms the digit and then moves to the final digit of the Time set-
point, or the exponent of the pressure set-point. The exponent of the pressure set-point is adjusted as a single value
in the range -10 to +6.
The final press of ENTER confirms the complete number and returns to showing the set-point value. The TSP is set
after the complete number is entered.
Change TSP
Number
To Next Page
Loading...
