EEC SE 7441 - Page 71

63
two small meters on the top of the screen display the Hi Limit Real and Dwell Time. Touch any of
the parameters and drag it on to the location of a different parameter and the two meters will be
swapped. For example in the next screen the Hi Limit Total is the smaller meter and the Hi Limit
Real is the bigger meter.
Default System Parameters
SE comes from the factory with the following system presets:
SYSTEM PARAMETERS
Setup Sys.
PLC Remote
OFF
Single Step
OFF
Fail Stop
ON
Alarm
5
Results
Last
Address (GPIB only)
8
Smart GFI
ON
Results
Last
Cal Alert
ON
Security
Password from Factory
0
Security based on Password
OFF
Memory, Step, and Default System Parameter Initialization
Initializing the instrument will overwrite all memories and steps with ACW
default parameters!
All memories and steps will be loaded with the ACW default parameters and the System
parameters will be set to the factory defaults. The default system parameters are as follows:
Setup Sys.
PLC Remote
OFF
Single Step
OFF
Fail Stop
ON
Results
Last
Address (GPIB only)
8
Smart GFI
ON
Results
Last
Cal Alert
ON