AutoCal V3 User Guide
support@efilive.com - 11 - www.efilive.com
Remove ALL connectors before transporting or storing devices. Failure to
do so may cause internal connections to break.
Never wrap cables around devices that are still connected, even when not
in use. Doing so can put excessive stress on the internal connectors and
can cause them to break.
Do not allow uninsulated wires to contact any part of the vehicle’s chassis
or electrical system. Take particular care to never allow devices, or any
wires connected to devices, to contact the vehicle’s battery terminals or
other power source.
Never use a DC to AC power inverter to operate your laptop while
FlashScan V3 or AutoCal V3 is connected to either the vehicle or the laptop
or both.
To Next Page
Loading...