AutoCal V3 User Guide
support@efilive.com - 31 - www.efilive.com
V8 Scan and Tune *.htx files
When V8 Scan and Tune software reads or flashes a controller the details of the
read/flash process may be saved in trace files for diagnostic purposes.
In addition, users can manually save trace files where options do not perform the
desired outcome.
To manually generate a trace file, generate the error in V8 software, then open the
EFILive Control Panel and navigate to [F8: Trace] and select [Save Trace]. Users
can set the trace file and save location during this process.
Automatically generated trace files are created on your PC or laptop in the folder:
\Documents\EFILive\V8\Trace and are named using the following naming
convention:
YYYYMMDD_HHNNSS_T_CCC.htx, where:
YYYYMMDD: is the year, month and day that the trace was recorded.
HHNNSS: is the hour, minute and second that the trace was recorded.
T: is the mode and is one of R=Read F=Full-Flash W=Cal-Flash.
CCC: Is the controller type
htx: is the file extension.
Warranty
EFILive will provide a 12 month warranty on all labour and materials.
For AutoCal, customer warranty claims should be made through the Tuner that
provided the AutoCal device.
AutoCal V3 must be registered to activate the product warranty. Product
registration and warranty information can be entered on the EFILive website
directly using the Product Registration form.
The terms and conditions of the warranty can be found in the Warranty Policy.
To Previous Page
Loading...