AutoCal V3 User Guide
support@efilive.com - 10 - www.efilive.com
V8 Scan and Tune software
1. Connect AutoCal V3 to your PC.
2. Open V8 Scan and Tune software.
3. Select [F7: Licenses].
4. The license number indicates the FlashScan that AutoCal is linked to.
5. Where the license number and serial number are identical, the AutoCal
device is not linked.
AutoCal V3
1. Connect AutoCal V3 to power.
2. Accept the EULA.
3. Navigate to [F4: Options] -> [F3: About] -> [F1: Firmware].
4. The license number indicates the FlashScan that AutoCal is linked to.
5. Where the license number and serial number are identical, the AutoCal
device is not linked.
Unlinking AutoCal
An AutoCal can be unlinked from a FlashScan device to allow that AutoCal device
to be relinked to another FlashScan device.
Unlinking an AutoCal is at the sole discretion of the tuner. End users should make
appropriate inquiries on the tuner's unlinking policy prior to purchase. EFILive
(and other parties) cannot provide this service.
There are two ways to unlink an AutoCal device from a FlashScan.
1. Physically Unlink AutoCal; where the tuner requires both FlashScan and
AutoCal to unlink the device.
2. Remotely Unlink AutoCal; where the tuner will send you an activation code
and instructions on how to unlink your AutoCal from the tuner’s FlashScan.
Once an AutoCal has been unlinked, it must be linked to another FlashScan prior
to flashing tune files.
Once AutoCal is unlinked, all tune files that were created by the original tuner with
the original FlashScan can no longer be flashed by the AutoCal device.
Tuners should implement a process to ensure the end user’s stock file is
converted from the original FlashScan to the new FlashScan. Failing to do so will
prevent end users from flashing their stock tune.
Once an AutoCal has licensed a controller, that controller will remain licensed to
that AutoCal. Unlinking and relinking an AutoCal device does not require
additional licensing provided the controller originally tuned remains the same.
Additional AutoCal VIN licenses are required to tune additional controllers.
Taking Care of AutoCal V3
Care must be taken when using, transporting or storing AutoCal V3.
Never leave devices in direct sunlight; it will damage the LCD screen and
the polycarbonate keypad.
Never expose devices to solvents or other corrosive or oxidizing agents.
Do not immerse devices in any liquid.
Do not expose devices to high temperatures or open flames.
To Next Page
Loading...