AutoCal V3 User Guide
support@efilive.com - 7 - www.efilive.com
Software Requirements
EFILive V8 Scan and Tune application must be installed for file management.
For AutoCal to be functional, the software and firmware used with your AutoCal
will need to be compatible the software and firmware used with your tuner’s
FlashScan device.
AutoCal users should only update software and firmware at their
tuners specific request. Updating to software and firmware versions
higher than your tuner may lead to your tuner being unable to offer
you support until they update.
Licensing
Each AutoCal device ships with one VIN license that may be used for tuning one
engine controller. Supported transmission control modules do not require a VIN
License.
Tuners can manage the number of available VIN slots they wish their AutoCal
devices to hold. AutoCals will ship with a default maximum VIN slot count set to 1.
AutoCal V3 is configurable to a capacity of 600 VIN licenses.
Updating VIN slot limits is at the sole discretion of the tuner. EFILive (and other
parties) cannot provide this service.
Although AutoCal can be used to return a vehicle to stock, doing so will not “reset”
the VIN license that was used to flash the vehicle. A future version of EFILive
software will allow VIN licenses to be copied from one FlashScan or AutoCal
device to an AutoCal V3 device where the device license numbers match on both
devices. Details will be provided at a later date.
License slot limits can only be viewed via V8 Scan and Tune software. Used and
available VIN Licenses can be viewed in both V8 Scan and Tune software and on
AutoCal V3;
V8 Scan and Tune software
1. Connect AutoCal V3 to your PC.
2. Open the V8 Scan and Tune software.
To Next Page
Loading...