AutoCal V3 User Guide
support@efilive.com - 5 - www.efilive.com
What is AutoCal?
EFILive’s AutoCal V3 provides a convenient platform for professional tuners to
distribute custom tunes to their customers. And for their customers to collect and
submit logged data back to the tuner for analysis. It allows the tuner to update and
optimize the original tune without shipping and/or removing controllers from
customers’ vehicles.
AutoCal can be configured in a variety of different ways to best suit your tuner’s
operational requirements and the needs of their customers. Your tuner may
provide additional support documentation tailored to the specific setup they use for
AutoCal
Differences between FlashScan and AutoCal
There are significant differences between FlashScan and AutoCal for end users. It
is important that both the tuner and the tuner’s customer (end user) understand
these differences.
With FlashScan, users have the ability to create, view, and modify tunes. With
AutoCal, only the tuner has that ability.
AutoCal cannot be used to create or change tune files.
Tunes from multiple sources can be flashed with FlashScan, however AutoCal is
limited to flashing tunes provided by a single tuner.
A FlashScan Device is Required
FlashScan is required to create tunes for an AutoCal device. AutoCal devices
cannot create tunes.
End User License Agreement
The EULA is displayed when the EFILive V8 Scan and Tune software is installed.
Installation cannot proceed until the user agrees to the EULA.
The EULA is displayed on the AutoCal V3 screen each time AutoCal V3 is
connected to power. For AutoCal V3 to be functional, the user must agree to the
EULA.
Where AutoCal V3 is connected to a PC and is being used in pass-thru mode, the
device will be functional even if the EULA is not confirmed on the AutoCal V3
display because the EULA was accepted during software installation.
The [F7: Licenses] -> [F2: Hardware] tab will display the EULA status of the
connected device. The EULA status is updated on the first acceptance of the
EULA on the AutoCal V3 device.
To Next Page
Loading...