AutoCal V3 User Guide
support@efilive.com - 16 - www.efilive.com
6. Select [Program Quick Setup] to program device settings, controller
configuration and tune files to your AutoCal.
Program Configuration Settings
This process is used to make changes to Scan and Tune controller selections and
PID configurations on AutoCal if your tuner does not send a Quick Setup file.
1. Save the Options.txt file your tuner sent to the folder
\Documents\EFILive\V8\Config
2. Connect AutoCal to your PC and open V8 Scan and Tune software.
3. Select [F5: BBX]
4. Select Open, and navigate to your required Options.txt file.
5. Do not modify any of the settings defined by your tuner unless they request
you to.
6. Select appropriate [Program] option. There are 4 options available. Your
Tuner should assist you in choosing the correct selection.
Program (Ctrl+P) Programs the attached device with the current
configuration and any supporting files that have been updated since the
device was last programmed.
Program Selections Only (Faster) programs the attached device with
only the configuration file. This option should only be used if you have only
changed PID selections. If you have changed the number and or type of
controllers for either scanning or tuning then you should use the Program
or Program All Required Data options.
Program Selections and Configuration Files (Slower) formats and then
programs the attached device with all configuration files regardless of
whether they are out of date or not.
Format CONFIG File System formats the CONFIG file system in which
the configuration and supporting files are stored. When making significant
changes to the BBX options, it is a good idea to format the CONFIG file
system to discard any old/unused files prior to programming.
Program Device Settings
This process is used to make changes to AutoCal device settings if your tuner
does not send a Quick Setup file.
1. Save the Settings.dat file your tuner sent to the folder
\Documents\EFILive\V8\Config
2. Connect AutoCal to your PC and open V8 Scan and Tune software.
3. Select [F6: Devices]
4. Select Open, and navigate to your required Settings.dat file.
5. Do not modify any of the settings defined by your tuner unless they request
you to.
6. Select [Program] to program device settings.
Using AutoCal V3 as a USB Thumb Drive
Use AutoCal V3 as a USB Thumb Drive to move/copy files to/from AutoCal V3.
Use windows explorer to manage the files and folders. To ensure data integrity,
eject the thumb drive from Windows Explorer before disconnecting the device.
1. Connect AutoCal to your PC.
To Next Page
Loading...