EFILive AutoCal V3 - Page 23

AutoCal V3 User Guide
support@efilive.com - 21 - www.efilive.com
Tune Tool -> [F1: Tuning] menu
F1: Read Tune; Read the attached controller.
F2: Program Cal; Calibration flash the attached
controllers.
F3: Program Full; Full-flash the attached
controllers.
Tune Tool -> [F2: Injectors] menu
F1: Read GMP Injectors; Read and save injector
calibration data from Glow Plug Module.
F2: Prog GMP Injectors; Program previously
saved injector calibration data into Glow Plug
Module.
F3: Read ECM Injectors; Read and save injector
calibration data from Engine Control Module.
F3: Prog ECM Injectors; Program previously
saved injector calibration data into Engine Control
Module.
Tune Tool -> [F3: Switch Tunes] menu
F1: Switch CSP5; Switch between custom CSP5
tunes.
F2: Switch DSP5; Switch between custom DSP5
tunes.
F3: Switch DSP4; Switch between custom DSP4
tunes.