Efka AB600A5010 - Technical Level Parameters (Code No. 1907) (Continued)

- AB600A5010 Parameter List
- 54 -
Parameters
Designation
Unit
Max
Min
Preset
Ind.
180 rd
Reversing angle
Degrees
359
0
175
181 drd
Switch-on delay of reverse motor rotation
ms
990
0
10
182 Frd
Reverse motor rotation On/Off
1
0
0
184 c6
Number of run-out stitches when unlocking the chain
Stitches
254
0
20
190 mEk
Function “unlock the chain” in modes 5, 6 and 7 (Parameter 290)
0 = Unlocking off
1 = Unlocking the chain manually (with pedal in pos. –2 without
cutting at the seam end)
2 = Unlocking the chain automatically
- By means of light barrier or
- pedal in pos.-2 (Parameter 019) without cutting at the seam
end
3 = Unlocking the chain automatically
- By means of light barrier or
- Pedal in pos. –2 (Parameter 019) with cutting and run-out
stitches (Parameter 184) at the seam end, then unlocking the
chain (only if parameter 290 = 7)
4 = Unlocking only with pedal 2
No unlocking the chain at the seam end by means of light
barrier, cutting and run-out stitches.
4
0
1
191 mhE
Seam end for overlock mode through
End count c2 or c4
0 = Seam end after count c4 – Tape cutter
1 = Seam end after count c2 – chain suction
1
0
0
192 PLS
Speed of the light barrier compensating stitches
0 = Speed n5 after light barrier sensing
1 = Speed pedal controlled
1
0
0
198 Bag
Functions with chainstitch machines e. g. bag sewing machine
(Parameter 290 = 37)
0 = Function “thread trimming” or “hot thread chain cutting” and
sewing foot lift using the pedal.
1 = Function “thread trimming” or “hot thread chain cutting” using
the knee switch, and sewing foot lift using the pedal.
2 = Function “thread trimming” or “hot thread chain cutting” using
the pedal and sewing foot lift using the knee switch.
2
0
0