EggRider V2 - Page 53

6.2.4 Bafang throttle settings
Buttons
Initialize
- Reads all Bafang Basic/Pedal/Throttle settings at once. After this procedure both Road/ORoad
would have identical settings.
Road
or
OffRoad
- switch between proles.
Read controller
- reads controller Throttle settings.
Info
- provides information for the Bafang switch mode.
Write
- writes the Throttle settings to controller. If the operation is successful it updates the settings on the
display as well.
BASIC
DESIGNATED ASSIST
The value of the assist power level.
If set to Display command the assist level shown on the display would be considered.
SPEED LIMIT
The value of the speed limit.
If set to Display command the value from Max Speed Road or Max Speed ORoad from Display settings
page will be used.
START CURRENT (%)
Percentage of available current when throttle initially applied.Lower values for smoother startup:
5
or
10
gives a much smoother startup. This can be set all the way down to
1
.
Accessible from menu Bafang Throttle
To disable throttle set Dessignated Assist = 0 and in Bafang Basic page set for Assist 0, Limited Current(%) = 0 and Limited
Speed(%) = 0.
Tip
To have always maximum power for throttle set Dessignated Assist = 9 and in Bafang Basic page set for Assist 9, Limited
Current(%) = 100 and Limited Speed(%) = 100.
Tip
6.2.4 Bafang throttle settings
- 53/89 -
Copyright © 2019 EggRider.