ADVANCED
THROTTLE MODE
Options
Speeed
Current
START VOLTAGE (X100MV)
This is the throttle input starting voltage. The point at which the controller responds to input is at 1.1 volts,
so set value to 11 which = 1.1 volts. As you begin to roll on the throttle the voltage moves up from zero and
when it reaches 1.1v the motor begins to turn. Best to leave between 10 and 15. Too low and the display will
throw an error as the motor will want to run continuously. If you change the throttle you will need to nd the
new lowest setting.
END VOLTAGE (0X100MV)
You can set the max range to 42 which is the max input the controller accepts from throttle input 4.2v. If you
set lower than this value your throttle response is not as linear or smooth as it could be.
•
•
Switching this to Current Mode (instead of Speed mode) has an improvement in the throttle response smoothness.
Tip
Do not change this value unless you really know what you are doing.
Attention
Do not change this value unless you really know what you are doing.
Attention
Last update: November 5, 2020
6.2.4 Bafang throttle settings
- 54/89 -
Copyright © 2019 EggRider.
To Next Page
Loading...