EggRider V2 - Page 8

2.4.2 Battery
To have a good battery percentage , you have to set the Voltage 0%/100% and capacity in the Display
settings page.
Use the Battery Voltage drop down helper with predened values for Voltage 0% and Voltage 100%. You can
also manually adjust the values to your specic requirements.
The Wheel size drop down is just a helper with predened values for Wheel circumference. It is normal to go back to Select.
Info
These settings are used for battery measurements only, they don't inuence the voltage cutos for example. Use the controller
specic settings for protection.
Info
2.4.2 Battery
- 8/89 -
Copyright © 2019 EggRider.