Egro ONE - Powder Module; Powder Hopper

Technical Manual V6.00 22 01.05.2017
4.11. Powder Module
The preparation of a powder product is handled with a number of parameters described with the diagram below. The
parameters are split in the one, which are necessary to adjust for each product and the ones which are handled as a
machine parameter. Make sure to make the water calibration, in the product setup!
The menu is only in English, for other languages please refer to the software description.
Product configuration/
Powder delay
Product configuration/
Left powder amount
or Right powder amount
Fix values
(not configurable)
Product configuration/
Water delivery
Product set up/
Stop Mixer
Product set up/
Mixer delay
Product set up/
Hopper delay
4.11.1. Powder hopper
The powder hoppers are cleaned with the mechanics mounted. In special circumstances, it is necessary to take apart the
mechanics to replace some parts. When reassembling, it is important to have the right order and placements of the parts
to secure a proper function. Some parts are similar and can easily be mixed up.
Front nut
Back nut
Back assembly
Front components